Tensile testing is a fundamental mechanical test used to determine how materials behave under uniaxial tension. In a tensile test, a sample is gripped at both ends and pulled apart at a constant rate until it either breaks or reac...

Compression testing evaluates how materials behave under crushing forces. It determines compressive strength, deformation, and modulus of elasticity. Common in foam, concrete, plastics, and rubber testing. Typical Standards: ASTM...

This test determines a material’s flexural strength and stiffness. UTMs use a three-point or four-point bending fixture to apply force to a sample supported on both ends. Typical Standards: ASTM D790, ISO 178 Key Equipment:...

Shear testing measures a material's ability to resist sliding forces. It's widely used in adhesive, fastener, and composite testing. Typical Standards: ASTM D732, ASTM D1002 Key Equipment: Shear fixtures, v-blocks, and cu...

Tear testing evaluates the force required to tear a material, especially relevant in textiles, rubbers, and films. Typical Standards: ASTM D624, ASTM D1004 Key Equipment: Tear grips, specimen dies...

Peel testing is crucial for evaluating adhesive bonds, laminates, and flexible packaging. It includes 90° and 180° peel configurations. Typical Standards: ASTM D903, ASTM D3330, ASTM D1876 Key Equipment: Peel fixtures, pe...

Puncture testing determines how much force is needed to penetrate a material. Common in packaging films, membranes, and medical applications. Typical Standards: ASTM D5748, ASTM F1306 Key Equipment: Puncture probes, die-cut sampl...